By part number only
Browse by Manufacturer


on sale
Suggested retail: $43.00
Buy from us online and save! ***Online price***: $38.70
Part number:: ULTRAWF
Quantities are limited ***** Manufacturer Part #: ULTRAWF

The Frigidaire Puresource Ultra Filter ULTRAWF is a genuine Frigidaire replacement water filter that fits Frigidaire Pure Source Ultra refrigerators which feature a cylindrical filter housing mounted on the refrigerator's ceiling. The Frigidaire ULTRAWF filter will also replace part numbers 242017800 and A0094E28261.

The Frigidaire Pure Source Filter provides fresh, filtered drinking water by reducing the following contaminants:

  • Chlorine taste and Odor
  • Particulates (class 1)
  • Lead
  • Cysts
  • Turbidity
  • Atrazine (Herbicide)
  • 2,4-D (Herbicide) (VOC)*
  • Endrin
  • Toxaphene (Pesticide)
  • Mercury
  • Lindane
  • Alachlor
  • Benzene
  • P-Dichlorobenzene (VOC)*
  • O-Dichlorobenzene
  • Ethylbenzene
  • Chlorobenzene (VOC)*
  • Monochlorobenzene
  • Styrene
  • Tetrachloroethylene
  • TTHM
  • Carbofuran (VOC)*
  • Asbestos
  • 2,4,5-TP (Silvex) (VOC)*
  • 1,2,4 Trichlorobenzene

*The Frigidaire Puresource Filter (ULTRAWF) conforms to NSF / ANSI Standard 53 for VOC reduction, with a VOC surrogate average reduction of 99.8 percent.

Frigidaire Pure Source Ultra Filter Specifications:

  • Press. Range: 30 - 100
  • Temp. Range: 33 - 100 F
  • Flow Rate: 0.5 gallons per minute
  • Capacity (Filter Life): 6 months or 200 gallons

This genuine Frigidaire refrigerator filter has been tested and certified to NSF / ANSI Standards 42 and 53 in Frigidaire Pure Source Ultra refrigerators for the reduction of the claims specified.
In general, you should change the water filter every six months to ensure the highest possible water quality. The Water Filter Status light on the Touch Panel prompts you to replace the filter after a standard amount of water (200 gallons/757 liters for PureSource UltraTM) has flowed through the system.

To replace your PureSource UltraTM water filter:
It is not necessary to turn the water supply off to change the filter. Be ready to wipe up any small amounts of water released during the filter replacement.
1. Turn Off the ice maker power switch.
2. Remove the filter by pushing on the end/face of the filter.
3.Slide the old water filter cartridge straight out of the housing and discard it.
4. Unpackage the new filter cartridge. Using the alignment guide, slide it gently into the filter housing until it stops against the snap-in connector at the back of the housing.
5. Push firmly until the cartridge snaps into place (you should hear a click as the cartridge engages the snap-in connector).
6. Press a drinking glass against the water dispenser while checking for any leaks at the filter housing. Any spurts and sputters that occur as the system purges air out of the dispenser system are normal.
7. After filling one glass of water, continue flushing the system for about three minutes.
8. Turn On the ice maker.
9. Press and hold the Filter Status button on the Ice & Water Dispenser control panel for three seconds. When the display changes from “Replace” to “Good,” the status has been reset.